PoE Power Budget Calculator

A PoE switch has a total power budget as well as a per-port limit, and it is easy to run out before you run out of ports. Enter the switch’s PoE budget and the devices you plan to plug in to check that everything will power up, and which PoE standard the hungriest device needs.

DeviceHow manyTypical watts each
Fixed IP camera802.3af, reserves up to 15.4 W
IP camera, bright IR / 4K802.3af, reserves up to 15.4 W
PTZ camera802.3at (PoE+), reserves up to 30 W
PoE video doorbell802.3af, reserves up to 15.4 W
Wi-Fi 6 / 6E access point802.3at (PoE+), reserves up to 30 W
Wi-Fi 7 access point802.3at, some need 802.3bt, reserves up to 30 W
VoIP desk phone802.3af, reserves up to 15.4 W
Raspberry Pi with PoE+ HAT802.3at (PoE+), reserves up to 30 W
Other PoE deviceclass worked out from its watts

Typical watts are rough figures for common models. Use the maximum power figure from your device’s spec sheet if you have it.

Power needed–
Budget used–
Headroom–
  • PoE ports needed–
  • Typical draw with 10% margin–
  • Class maximum (worst case)–
  • Hungriest device needs–

Some switches reserve each port’s full class maximum when a device connects; others allocate by actual draw. If your switch’s manual says it allocates by class, use the class maximum setting.

PoE standards at a glance

  • 802.3af (PoE): up to 15.4 W per port at the switch, about 12.95 W at the device. Enough for most fixed cameras and phones.
  • 802.3at (PoE+): up to 30 W at the switch, about 25.5 W at the device. Needed by most Wi-Fi 6 and Wi-Fi 7 access points and PTZ cameras.
  • 802.3bt Type 3: up to 60 W at the switch, about 51 W at the device.
  • 802.3bt Type 4: up to 90 W at the switch, about 71 W at the device.

The difference between the switch figure and the device figure is the power lost in the cable, which is why the class figures above are higher than what a device draws.

Tips for sizing a PoE switch

  • Leave about 20% headroom. Cameras draw more at night with IR on, outdoor units with heaters draw more in winter, and PTZ cameras spike while moving.
  • Check per-port limits too. A switch with a 120 W budget may still only offer 802.3af on some ports.
  • Plan for growth. Adding two more cameras later is common; a slightly larger budget now is cheaper than a second switch.

Related: Best PoE camera system · NVR storage calculator · Best 2.5GbE switch · Today’s home lab deals

For general informational purposes only; not professional advice. Posts may contain affiliate links. Learn more.
Scroll to Top